The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > 47 - Current classic GM Trucks > The 1960 - 1966 Chevrolet & GMC Pickups Message Board

Web 67-72chevytrucks.com


 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 04-16-2018, 01:18 PM   #1
Krispykreme64
Registered User
 
Join Date: Dec 2017
Location: Crosby, Tx
Posts: 8
Pics and advice needed for the best wheel offset to clear on a bagged C10

So recently I replaced my suspension on my 64 C10 with Accuair, did a Dead end Garage kit on it (mini C-notch, shock re-locators, and re-located the exhaust) did everything correctly but it only goes to the mini C-noth (still 6 inches off the ground) BUT now I want to go all the way to the ground already....... I purchased a set of 18" Mob Steel wheels during all this and the offset i went with is too wide, it's perfect almost too perfect for the stance i have now but lower is not an option. My rear wheels will need to change for sure but my front may clear but not too sure until I can lay it down and mock it up. What's the most common offset everyone is going with on these wheels for bagged trucks? Could really use some input and pics before i spend another $1300 on wheels AGAIN.
And yes I have measured and have an idea, just seeing if anyone else has a better grasp on the subject, this is my first build.
Attached Images
 
Krispykreme64 is offline   Reply With Quote
 

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 05:34 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com