Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
04-09-2018, 07:18 AM | #1 |
Registered User
Join Date: Aug 2015
Location: mi
Posts: 45
|
Heater question concerning coils in vent
Just purchased the American wire kit and in the process of redoing all of my wiring. I followed the wiring to the heater box and it was connected to a coil that is snapped into the back of the metal vent coming from engine bay. Is that more of a heater coil that gets hot when turned on? How do you check it to make sure it works or just better off getting new? Where can I buy this at? Looked at LMC but I didn't see it but I might of missed it also
|
04-09-2018, 09:23 AM | #2 |
Senior Member
Join Date: Apr 2016
Location: Cypress, TX
Posts: 3,513
|
Re: Heater question concerning coils in vent
It sounds like you are talking about the heater resistor. My older LMC catalog has it on p166. It allows the fan blower to operate on the medium speeds. There is a different one for trucks with A/C. No need to replace it unless it is burned out or broken. Check if your blower works on medium.
|
04-12-2018, 06:32 AM | #3 |
Registered User
Join Date: Aug 2015
Location: mi
Posts: 45
|
Re: Heater question concerning coils in vent
Thanks, I ended up just buying a new one for $10 along with all the other stuff you always seem to need
|
Bookmarks |
Thread Tools | |
Display Modes | |
|
|