|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
03-21-2013, 12:52 AM
|
#26 |
|
Registered User
Join Date: Aug 2002
Location: Westbank, BC
Posts: 401
|
Re: pinion angle help after lowering (W/drawing)
The 200r4 is probably 1" difference from centreline of output shaft to the trans mount surface compared to a TH-400. I had to shim mine up an extra inch, but my swap was a ST-300 not a TH-400.
Might want to check that. Brian Posted via Mobile Device
__________________
1965 Chevy Short Box Stepside, 230 - 3 speed, 4:11 gears, original paint rust free survivor. Now sporting a 383 SBC and TKO-600 |
|
|
|
03-23-2013, 12:49 AM
|
#27 |
|
Registered User
Join Date: Dec 2007
Location: Southington CT
Posts: 548
|
Re: pinion angle help after lowering (W/drawing)
OK so the 3 deg shims arrive today, Have to work tomorrow, but will get these in on Sunday and take a test drive....
I will let everyone know how it goes, Might even shoot a video using the gopro just because I can     I have to say thanks to the guys over at Carls.. they where topnotch, truly pro's in their field!!! Scott
__________________
68-SWB, 327, hooker headers, spintec mufflers, disk brake 3.5/5 drop, buddy buckets, 200-4R, 2200 stall, 3.73 12bolt Eaton Posi,  My 68-SWB Photo Build Thread All my Google Albums |
|
|
|
|
02-03-2019, 09:31 PM
|
#28 |
|
Registered User
Join Date: Apr 2018
Location: Medina, Ohio
Posts: 18
|
Re: pinion angle help after lowering (W/drawing)
You never updated us after you shimmed rear-end (at least I don't c it). Did it solve your 2013 issue? Only asking because I'm dealing with same. Thanks!
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
