|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
06-02-2003, 09:24 PM
|
#1 |
|
turnin wrenches
Join Date: Dec 2002
Location: my garage
Posts: 263
|
rocker/ cab corner ????'s
ok i am getting ready to replace both rocker and cab corner on both sides of the cab...........in removing the old rockers, i am assuming i have to replace the corners first then the rockers.........this is my first bit of body-metal work other than adding some sheet metal to the floor of my 82 jimmy.any help or suggestions would be greatly appreciated.......
thanx BBB 
__________________
"three can keep a secret if two are dead" -unknown hell's angel- D.M.C. -FF- 68 SWB full frame off (project ol skool) 2000 s-10 formally bagged but now my daily driver... |
|
|
|
06-02-2003, 10:05 PM
|
#2 |
|
Account Suspended
Join Date: Mar 2001
Location: Virginia Beach, Va. U.S.A.
Posts: 15,320
|
For the cab corners, only use as much of the new patch that is needed to fix the rust. You don't need to use the entire patch!!
|
|
|
|
|
06-03-2003, 02:27 AM
|
#3 |
|
turnin wrenches
Join Date: Dec 2002
Location: my garage
Posts: 263
|
ttt
__________________
"three can keep a secret if two are dead" -unknown hell's angel- D.M.C. -FF- 68 SWB full frame off (project ol skool) 2000 s-10 formally bagged but now my daily driver... |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
