|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
09-26-2018, 12:08 AM
|
#10 |
|
Registered User
Join Date: Dec 2009
Location: Independence Mo
Posts: 4,118
|
Re: Finish Wiring of a Stand Alone Harness
Ok, I see. I didn't realize the first pic was a diagram of the harness you have. So basically you would wire it up like the second pic, at least the fuse block part, on the right side. Only difference would be you will only have 2 ignition fuses rather than the 3 in that pic. The other things will go to what ever they are for, MIL will go to the check engine light, TCC will go to the brake switch, etc.
__________________
My '72 short bed build. http://www.ls1tech.com/forums/conver...6-0-4l80e.html 5.3 swap into my RUSTY '71 C10 http://ls1tech.com/forums/conversion...71-c-10-a.html |
|
|
| Bookmarks |
|
|
Threaded Mode