The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > General Truck Forums > Engine & Drivetrain > LSx Swaps

Web 67-72chevytrucks.com


 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 05-23-2018, 05:13 PM   #1
Jferrante
Senior Member
 
Jferrante's Avatar
 
Join Date: Jan 2015
Location: Princeton NJ
Posts: 358
Starter Wiring Help

I have a 6.0 with a PSI harness and am having trouble wiring this up correctly.
I have the main hot from the battery on the main post, the 2 black wires on the same post (per PSI instructions) then I have the Red wire that comes from the drivers side fuse block - this is where I am having an issue. If I put the red wire to the main post it doesn't turn over, if I put it on the small post of the starter I get it to run the starter but even when the key is off.

My troubleshooting is either the wiring at the relays is wrong or I am missing something altogether at the starter. I should only have starter full circuit with the key in the on position....
Any help is appreciated.
Jferrante is offline   Reply With Quote
 

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 06:24 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2018, vBulletin Solutions Inc.
Copyright 1997-2013 67-72chevytrucks.com