|
01-30-2010, 08:07 PM
|
#1 |
|
Registered User
Join Date: Jan 2010
Location: nova scotia
Posts: 39
|
cab swap
hi, i need help swapping a manual 1991 cab on to a 1990 gmc automatic truck. what do i need to disconnect on both cab to do the swap.
|
|
|
|
01-30-2010, 10:16 PM
|
#2 |
|
The One And Only !!!
Join Date: Jan 2007
Location: Hole in the woods Florida
Posts: 4,567
|
Re: cab swap
Anything that goes from the running gear (engine compartment) to the body;
Front clip (fenders) Steering column @ rag joint Shift linkage @ column Wire harness @ fire wall AC/heater hoses @ cab Brake lines @ master cylinder I'm sure there are a few more I left out but that's a good start.... Good Luck
__________________
93 Jeep XJ 88 Buick La Sabra Toys; 88 TA-GTA in the works.... 97 GMC Ext. Cab 502 Crate 5 Spd......Sucks Gas But Haulz Azz !  The primary function of an Engineer is to make it difficult for the Fabricator and impossible for the Mechanic. "Why go out preserved when you can go out beat up, worn out, sliding in sideways screaming, Holy Sh!t What A Ride" !!!
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
