|
10-24-2015, 12:11 AM
|
#1 |
|
Registered User
Join Date: Jun 2012
Location: Sacramento, Ca
Posts: 69
|
Fuse Block
I have the original fuse block, but want to add a cig lighter, glove box light....should I update the entire fuse block? When it says that it is a 13 circuit block, does that mean it had 13 different connection?
|
|
|
|
10-25-2015, 04:00 PM
|
#2 |
|
Registered User
Join Date: Jan 2013
Location: San Antonio, TX
Posts: 733
|
Re: Fuse Block
subbed
__________________
Figure out what you want--then figure out what you are willing to give up to get it. |
|
|
|
|
10-25-2015, 06:01 PM
|
#3 |
|
Registered User
Join Date: Nov 2009
Location: Sherman, ME
Posts: 2,354
|
Re: Fuse Block
A cig lighter and glove box light were factory available options. So there is a provision for them to plug directly into the original fuse box. Look for the terminal labeled "CIG" that's between the "AIR COND / HEAT" and "TRAFFIC HAZ" fuses.
That terminal is un-fused but it is protected by a fusible link in the feed wire (fusible link is located in the engine compartment). I don't think the factory cig lighter had a separate inline fuse but adding one would be a good idea. |
|
|
|
|
11-02-2015, 08:10 PM
|
#4 |
|
Registered User
Join Date: Jun 2012
Location: Sacramento, Ca
Posts: 69
|
Re: Fuse Block
Thank you. I did locate the connections but there is something else plugged into the CIG and I need to locate where the wire leads to. Thanks again.
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
