No Limit X-Member Kit on a TF - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**idbeast** · 01-14-2018, 05:23 PM

No Limit X-Member Kit on a TF.
I'm going to post this here as I couldn't find any pictures or information about it other then the No Limit web site!
The C-channel boxing plates and X-plates look like they would be a much stronger setup. My engine dynoed out with 517hp so it is a little bit more than the factory V-8. So I took and completely stripped the truck again, and started putting in the square tubing from one side of the frame to the other. I thought it would be smart to X everything, only to find out that it was a big mistake and it raised the passenger side rear corner 1/4 inch do to the welding of the last X piece, so I removed the X and everything went back to normal.

01-14-2018, 05:23 PM	#1
idbeast Senior Member Join Date: Oct 2016 Location: Olympia, WA Posts: 520	No Limit X-Member Kit on a TF No Limit X-Member Kit on a TF. I'm going to post this here as I couldn't find any pictures or information about it other then the No Limit web site! The C-channel boxing plates and X-plates look like they would be a much stronger setup. My engine dynoed out with 517hp so it is a little bit more than the factory V-8. So I took and completely stripped the truck again, and started putting in the square tubing from one side of the frame to the other. I thought it would be smart to X everything, only to find out that it was a big mistake and it raised the passenger side rear corner 1/4 inch do to the welding of the last X piece, so I removed the X and everything went back to normal. Attached Images



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.