Roller bearings for front hubs - The 1947 - Present Chevrolet & GMC Truck Message Board Network

qksilver · 10-13-2005, 11:36 PM

I am trying to put a 58 panel on the road. Payed way to much for it, rusty but solid.
I haven't decided if it's worth doing completely. I want to make it road worthy, runs and steers well.
i want to update the wheel bearings and have seen the cost of the kits. Does anybody know the part numbers for the inner, outer bearings and grease seals
Thanks,
Steve

dwcsr · 10-21-2005, 09:38 AM

Its not just the bearings that need changing. You need a spacer for the bearing offset and seal ring. If you don't mind waiting a few days I can pull apart the old setup I used prior to putting an IFS in mine I can get you the numbers.

qksilver · 10-21-2005, 11:40 AM

Thanks, no hurry at all
Steve

10-13-2005, 11:36 PM	#1
qksilver Senior Member Join Date: Dec 2004 Location: Southern Pines NC Posts: 3,853	Roller bearings for front hubs I am trying to put a 58 panel on the road. Payed way to much for it, rusty but solid. I haven't decided if it's worth doing completely. I want to make it road worthy, runs and steers well. i want to update the wheel bearings and have seen the cost of the kits. Does anybody know the part numbers for the inner, outer bearings and grease seals Thanks, Steve

10-21-2005, 09:38 AM	#2
dwcsr Hollister Road Co. Join Date: Apr 2005 Location: Houston Posts: 6,134	Re: Roller bearings for front hubs Its not just the bearings that need changing. You need a spacer for the bearing offset and seal ring. If you don't mind waiting a few days I can pull apart the old setup I used prior to putting an IFS in mine I can get you the numbers.

10-21-2005, 11:40 AM	#3
qksilver Senior Member Join Date: Dec 2004 Location: Southern Pines NC Posts: 3,853	Re: Roller bearings for front hubs Thanks, no hurry at all Steve



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.