|
04-22-2019, 12:29 AM
|
#1 |
|
Registered User
 
Join Date: Jul 2015
Location: Fairfax, Missouri
Posts: 1,054
|
72 k10 dana 44
Can someone tell me how far the inner hub needle bearing should be pressed down. I can't seem to find any info except a dodge video saying it should be .220.
|
|
|
|
04-22-2019, 09:00 AM
|
#2 |
|
Registered User
Join Date: Jan 2019
Location: Pine bluffs, WY
Posts: 17
|
Re: 72 k10 dana 44
It should bottom out on the lip inside.
|
|
|
|
|
04-22-2019, 10:35 AM
|
#3 | |
|
Senior Member
Join Date: Mar 2003
Location: Colfax-California
Posts: 8,389
|
Re: 72 k10 dana 44
Quote:
220 is about right. The pocket bearing small black seal needs to protrude just a smidge so it will seal up against the back of the stub shaft. |
|
|
|
|
|
04-22-2019, 01:55 PM
|
#4 |
|
Registered User
Join Date: Jul 2015
Location: Fairfax, Missouri
Posts: 1,054
|
Re: 72 k10 dana 44
Ok guys I talked with torqking and the needle bearing gets pressed down so the seal that goes behind it sits flush . So the .220 is real close and tomorrow when I press it in I'll comment back. Thanks
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
