|
07-13-2017, 09:03 PM
|
#1 |
|
Registered User
 
Join Date: Nov 2011
Location: Dallas TX.
Posts: 1,053
|
Is this backwards?
Heater valve, I have seen this both ways, does it matter and is it backwards?
__________________
Dale - ApacheIvan 1972 Chevy Custom/20 Custom Camper Highlander http://67-72chevytrucks.com/vboard/s...d.php?t=740479 Original Owner ** Do you have a 1972 Plaid Pickup?** |
|
|
|
07-13-2017, 09:33 PM
|
#2 |
|
20' Daredevil (Ret)
Join Date: May 2003
Location: Jefferson State
Posts: 13,499
|
Re: Is this backwards?
That is mounted correctly, though it actually shouldn't matter. It opens / closes to control the flow of coolant. That said, coolant *might* flow better in one direction than in the other. But the pic shows the way they came from the factory.
__________________
- Mike - 1972 K20 LWB 350/350/205 RIP El Jay |
|
|
|
|
07-13-2017, 09:34 PM
|
#3 |
|
Moderator
 
Join Date: May 2007
Location: Southern Cal
Posts: 19,985
|
Re: Is this backwards?
It's correct.
__________________
1972 C/10 Cheyenne Super SWB. Restored, loaded, slammed. 1968 C/10 50th Anniversary LWB. Unrestored, stock, daily driver/work truck. RIP ElJay RIP 67ChevyRedneck RIP Grumpy Old Man |
|
|
|
|
07-13-2017, 10:19 PM
|
#4 |
|
Old member
Join Date: Jan 2002
Location: Liberty, & Garden City S.C. , U.S.
Posts: 19,936
|
Re: Is this backwards?
Doesn't really matter as long as it works.
I'd just about bet money the factory didn't care which way they where mounted back then. They where installed by a human and we all know humans make mistakes.So to say one way is correct and the other isn't is not really relivant.  
__________________
1971 LWB Custom, 6.0LS & 4L80E, Speedhut.com GPS speedometer & gauges with A/C. 20" Boss 338's Grey wheels 4 wheel disc brakes. My Driver Seeing the USA in a 71 Upstate SC GM Truck Club 2013,14 and 2016 Hot Rod Pour Tour http://upstategmtrucks.com/ Get out and drive the truck this summer and have some fun! It sucks not being able to hear! LWB trucks rule, if you don't think so measure your SWB! After talking to tech support at Air Lift I have found out that the kit I need is 60811. Per the measurements I gave them. Ride height of truck inside spring and inside diameter of springs. |
|
|
|
|
07-13-2017, 10:37 PM
|
#5 |
|
Senior Member
Join Date: Mar 2003
Location: Colfax-California
Posts: 8,393
|
Re: Is this backwards?
I must have the "Rare" factory backwards mounted valve with the corvettte 327 option. Must've been installed on a Monday. Sarcasm over.....
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
