Vision rally wheels

[kcstreetracer]

I am looking for some rallies and found some vision rally wheels on ebay. I'm looking to get 15x10 for rear and 15x8 for fronts. My question is the 10's are 4.25 backspace and -32 on offset. Are these going to work and not stick out? I'll be running a 30" tall tire that's 12" wide. I need them to tuck the bed. I dont have a bed on at the moment so I cant really measure and figure I'd ask. Thanks

[SCOTI]

Originally Posted by kcstreetracer

I am looking for some rallies and found some vision rally wheels on ebay. I'm looking to get 15x10 for rear and 15x8 for fronts. My question is the 10's are 4.25 backspace and -32 on offset. Are these going to work and not stick out? I'll be running a 30" tall tire that's 12" wide. I need them to tuck the bed. I dont have a bed on at the moment so I cant really measure and figure I'd ask. Thanks

They most likely won't "tuck" w/a stock set-up suspension wise. 'Fit' will depend on what body style, what drop amount (if any), & what rear end set-up.

[kcstreetracer]

Originally Posted by SCOTI

They most likely won't "tuck" w/a stock set-up suspension wise. 'Fit' will depend on what body style, what drop amount (if any), & what rear end set-up.

I have a fleetside, 5/7 drop on stock width rear. I like the rally wheels but being its 6 lug still my options seem pretty limited. Maybe I should hold off till its 5 lug.

[SCOTI]

Originally Posted by kcstreetracer

I have a fleetside, 5/7 drop on stock width rear. I like the rally wheels but being its 6 lug still my options seem pretty limited. Maybe I should hold off till its 5 lug.

So that "6-lug" statement suggests it's a pre-71 truck. Body style changes from 66 to 67 make a difference as well once you go past the 5/7 numbers.

My experience says for a 5/7 drop & 10" wheels, you'll prob be looking @ 5-5.5" BS for hassle-free clearance unless the rear end width is different or some other factor is involved. At 5.5" BS, a mini-tub might also be required. While it's possible to get away w/less than 5" BS, you will likely buzz the sidewall on the sheet metal.