The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > 47 - Current classic GM Trucks > The 1988 - 1998 GMT400 Chevy & GMC Pickups Message Board

Web 67-72chevytrucks.com


 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 07-02-2018, 04:40 PM   #1
crsgmc
Registered User
 
Join Date: Apr 2018
Location: Denver, CO
Posts: 23
Spark Plug Looms

I have spent a fair amount of time trying to find the factory spark plug dividers with no luck. I would just like to buy the plastic parts but would also buy the factory bracket. I have attached a picture of the drivers side rear bracket. You will notice that one of them is for three wires, this was replaced by someone in the past. This should be a two wire bracket. The other clip shown is missing the top closure. This is for a 1996 GMC K1500. The bracket mounts to the head below the valve cover. I would think that someone would make these plastic brackets. One of the currently available new GM crate engines uses the same bracket. Thanks for any help you can provide.
crsgmc is offline   Reply With Quote
 

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 12:00 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2018, vBulletin Solutions Inc.
Copyright 1997-2013 67-72chevytrucks.com