Rat repair.

[DD1]

Originally Posted by First c10

Hey Mike I used the brush on also. I could do a better job of getting it in the gaps and less clumpy.
I seen a video of a shop using brass filler rod and a tig welder. I think in the future I may try that.

Originally Posted by swamp rat

Mainly for ease of application, Seal any seam on both sides, any weld on both sides or any panel join. Per the rockers I don't know if its correct or not but I will put a little on both ends to fill in any small gaps and where the bottom is welded to the inner rocker on the back side, I do also intend to brush the seam sealer along the top where the inner and outer join just below the weather strip lip.

That's good information from both of you to store away for later. Don't know when I will need to worry about seam sealer, but now I know what to get and the best way to apply it. Thanks!