|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
04-13-2013, 10:06 AM
|
#1 |
|
Registered User
Join Date: Mar 2013
Location: Poconos Pa.
Posts: 29
|
93 c3500 spindles/brakes to 70 c/30
I have a 1970 C/30 long stepside. I would like info on using 1993 spindles as I have a very clean 3500 with good parts right next to my 70. This is why I would like to use these as opposed to the 73-87 crossmember swap. I have seen 1/2 to3/4 for the 6 lug but not 1 ton to 1 ton. Any info is greatly appreciated.
|
|
|
|
04-13-2013, 01:31 PM
|
#2 |
|
Registered User
Join Date: Apr 2001
Location: DALLAS,TX
Posts: 21,907
|
Re: 93 c3500 spindles/brakes to 70 c/30
If the lower BJ OD's are the same for the 70 C30 & the 93, just swapp the 93 spindles over & use the 93 upper BJ's on the 70's a-arms. If they're not the same size, you'll have to fab the lower BJ mount or use aftermarket arms set-up for the correct BJ. I'd hit your local auto parts place w/a caliper & measure the 2 different lower BJ's for a start.
__________________
67SWB-B.B.RetroRod 64SWB-Recycle 89CCDually-Driver/Tow Truck 99CCSWB Driver All Fleetsides @rattlecankustoms in IG Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive. It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar..... Cubic inches is like Indiana Jones with a cheap pistol. |
|
|
|
|
04-27-2013, 11:06 AM
|
#3 |
|
Registered User
Join Date: Mar 2013
Location: Poconos Pa.
Posts: 29
|
Re: 93 c3500 spindles/brakes to 70 c/30
Does anyone happen to have the specs on a 1 ton ball joint for a 1970 C/30? Mainly the out side dia. where the balljoint is pressed into the control arm. My local parts stores do not stock them. Once I order it it's mine. I don't want to start a balljoint collection if possible.
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
