The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > Info Center > FAQ Truck Tech > Engine and Drivetrain

Web 67-72chevytrucks.com


 
 
Thread Tools Display Modes
Old 05-19-2011, 03:23 PM   #1
NoNeck
Registered User
 
NoNeck's Avatar
 
Join Date: Jan 2011
Location: Chattanooga, TN
Posts: 1,025
Poor Man's Starter Heat Sheild

This little trick helped me out years ago on my '66 SS396 Chevelle with headers. Long before solenoid heat shields were available (1967), we had to improvise quite a bit when we made modifications to our "muscle" cars. Installing headers did (and still does) create their own set of problems. One of them being the dreaded heat soak caused from those big tube headers baking the starters to a crisp.

Back in the day, we would cut down old license plates and use them as heat shields. The key was to leave an open "dead air" space between the shield and the starter solenoid. The idea was to radiate heat and create a cooler air stream between the two.

Today, I started replacing the starter motor/solenoid in a 1968 C10 with a 327 and headers. I really wanted to order one of those fancy shields from JEGs, but since I am currently unemployed (and broke), I decided to make my own.

After searching for a while, I decided to use an old Rod Run plaque that I received many years ago at a car show. It was about the right size, made from aluminum, and thick enough to bend and modify.

Using a small paint can, I wrapped the plaque to form a semi-circle. Then, I marked the approximate location of the outside solenoid attachment screw. Using snips, I made a cut of about 3/8" and bent it down to form a tab. I drilled a hole in the tab large enough for the attachment screw.



After test fitting the shield, I sprayed the back side with High Temp Header paint... just for extra measure. It probably doesn't help dissipate heat.


The last photo shows the heat shield installed on the starter. Hmmmm... it feels just like 1967!



NoNeck
__________________
2013 Ram 1500 Express, Hemi, 395 HP
1966 Fairlane GT/A, 390/335 HP

If it costs you a dollar to make a friend, KEEP THE DOLLAR.
If it costs you a friend to make a dollar, KEEP THE FRIEND.

Last edited by augie; 05-09-2012 at 01:31 AM.
NoNeck is offline  
 

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 10:58 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2019, vBulletin Solutions Inc.
Copyright 1997-2013 67-72chevytrucks.com