|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
12-16-2014, 10:56 AM
|
#1 |
|
Registered User
Join Date: Mar 2013
Location: SF
Posts: 345
|
PB Fab A arms and Alignment shims
Tried asking this in the general section but didnt gain much traction... This may be a better spot
I installed the pb fab a arms but didn't take notice of how many shims I pulled out when i disassembled the original pieces. I put three shims in just because. Im assuming I can find an alignment shop close enough to me that I will only have to drive a few miles. Will that be ok? |
|
|
|
12-16-2014, 11:05 AM
|
#2 |
|
I'm just glad to be here!
Join Date: Jan 2008
Location: Longview, TX
Posts: 4,788
|
Re: PB Fab A arms and Alignment shims
Should not be an issue. looking at the truck from the front, do the tires look close to being vertical? Are they toed in or out to much?
If those issues look close, then driving a few miles to get to the alignment shop should nto be an issue..
__________________
Karl  1965 Chevy Stepside(Grandpa's Old Blue) and (July 2015 Shop Build!)(2020, the Saga Continues) http://67-72chevytrucks.com/vboard/s...d.php?t=372424 The LST Challenge: http://67-72chevytrucks.com/vboard/s...=1#post7812257 Korbin's 1st Square: "Sunburn" http://67-72chevytrucks.com/vboard/s...d.php?t=418618 1985 GMC Sierra: "White Trash", Korbin's 2nd now... http://67-72chevytrucks.com/vboard/s...d.php?t=632305 Henry - 1984 Chevrolet, Owen's 1st Square |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
