The 1947 - Present Chevrolet & GMC Truck Message Board Network

Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > General Truck Forums > Paint & Bodywork


Thread Tools Display Modes
Old 03-06-2017, 12:09 PM   #1
Registered User
Join Date: Jan 2017
Location: Wichita
Posts: 574
Coating back side of panels

I want to coat the back sides of my inner fenders, fenders, etc. At this time, I'm not looking for a show quality finish, this is just going to be a cruiser. For now I'm leaving the body in original patina form. I'll slowly get to the problem areas as time permits, but I want to drive her and enjoy in the meantime.

I have degreased the front section and I have metal prep as well. There are still areas with some rust and there's other areas that seem to have some sort of tar undercoating on them. What is my best course of action? I've thought POR-15 because it can go over the rust, but I worry, it'll be too hard to come back later and do any repairs or even remove bolts. Should I buy a good epoxy primer and spray it with that, or could I get by with some brush on rust-o-leum? At that point could/should I follow up with some sort of bed liner brush on/spray or what about the few cans of 3M rubberized undercoating?
MASTERBrian is offline   Reply With Quote


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -4. The time now is 01:22 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2018, vBulletin Solutions Inc.
Copyright 1997-2013