The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > 47 - Current classic GM Trucks > The 1960 - 1966 Chevrolet & GMC Pickups Message Board

Web 67-72chevytrucks.com


Reply
 
Thread Tools Display Modes
Old 11-13-2024, 03:13 PM   #1
AngryPirate
Senior Member
 
AngryPirate's Avatar
 
Join Date: Jan 2012
Location: Austin, TX
Posts: 564
60 GMC 305 v6 valve lash setting process

So, I’ve seen the other threads about this topic and it’s still not clear to me….

Here is my current understanding of the process and if correct, my valve lash was set completely wrong, set by the PO long ago.

1. Set them in firing order (while perhaps not necessary , might be quicker?) starting with cylinder 1.
2. Set current working cylinder valves when both intake and exhaust valves are closed.
3. Verify the cylinder is indeed at the top of the block (top of stroke) by peeking down the spark plug hole and then putting something long (so it can’t fall in) into the hole to watch cylinder movement
4. Set both intake and the exhaust valve lashes at the same time to their respective gap.
5. Move on to the next in the firing order (6 in the case of the first run through).
6. repeat steps 2-5


Does this sound correct?

Thanks for any help.
AngryPirate is offline   Reply With Quote
Old 11-16-2024, 02:07 AM   #2
Bob B.
Senior Member
 
Join Date: Aug 2005
Location: Los Angeles
Posts: 1,359
Re: 60 GMC 305 v6 valve lash setting process

That's the way I do it. Start with #1 cylinder on compression stroke, timing mark on TDC. Adjust valves on cylinder #1, then turn crank clock-wise 120 degrees. Next cylinder to adjust is #6, etc.
__________________
1967 GMC CM-2500 Camper Cruiser, 351E V-6, NP 435 4 speed, Dana 60, and factory A/C. 2012 GMC K-3500 WT regular cab, 6.0L Vortec, 6L90.
Bob B. is offline   Reply With Quote
Old 11-16-2024, 11:10 AM   #3
AngryPirate
Senior Member
 
AngryPirate's Avatar
 
Join Date: Jan 2012
Location: Austin, TX
Posts: 564
Re: 60 GMC 305 v6 valve lash setting process

Quote:
Originally Posted by Bob B. View Post
That's the way I do it. Start with #1 cylinder on compression stroke, timing mark on TDC. Adjust valves on cylinder #1, then turn crank clock-wise 120 degrees. Next cylinder to adjust is #6, etc.
I appreciate the response.
Thanks for the confirmation Bob B.
AngryPirate is offline   Reply With Quote
Reply

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 04:59 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com