|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
08-22-2015, 06:04 PM
|
#1 |
|
Registered User
Join Date: Feb 2010
Location: San Angelo, Tx
Posts: 1,068
|
Hood springs for '57 question
My hood sags down a little when open so my springs must be a little weak.
I want to make sure I get the best quality ones available. Any suggestions where I should buy them to insure I will get the best ones? Do stainless ones work any better? I don't care about the looks but would go for them if they work the best. |
|
|
|
08-22-2015, 07:07 PM
|
#2 |
|
Senior Member
  
Join Date: Nov 2008
Location: Glendora, CA
Posts: 6,331
|
Re: Hood springs for '57 question
Just buy stock reproduction springs from any of the major suppliers for these trucks and they'll work fine.
__________________
'55 Big Window Shortbed, Drive-It-&-Work-On-It slid down the "slippery slope" to a Frame-Off Rodstoration! LQ4/4l85e/C4 IFS/Mustang 8.8 rearend w/3.73's Dan's '55 Big Window "Build" - Well, Kinda! |
|
|
|
|
08-22-2015, 11:19 PM
|
#3 |
|
Registered User
Join Date: Apr 2008
Location: Kansas
Posts: 191
|
Re: Hood springs for '57 question
I bought a new set off ebay for a 55 chevy car. Chevy used the same spring for the cars and trucks. Amazing improvement in hood function, not only in holding hood up but also helps keep hood down tight on cowl.
|
|
|
|
|
08-23-2015, 09:25 AM
|
#4 |
|
Registered User
Join Date: Feb 2010
Location: San Angelo, Tx
Posts: 1,068
|
Re: Hood springs for '57 question
Thanks guys. Good to know.
I think I will get them from Brothers because I've got a a couple of other items I need too. |
|
|
|
|
08-30-2015, 11:46 AM
|
#5 |
|
Registered User
Join Date: Feb 2010
Location: San Angelo, Tx
Posts: 1,068
|
Re: Hood springs for '57 question
The stock reproduction springs from Brothers work great.
The hood stays open now. 
|
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
