|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
|
|
03-07-2017, 09:49 PM
|
#1 |
|
Registered User
Join Date: Mar 2001
Location: Houston, tx
Posts: 141
|
Help needed for new rebuild and unknown connector
On a 98 Suburban, I just rebuilt the engine. I got everything together, but I can't figure out where this connector goes. It doesn't go to the distributor, or the oil sendor at the back of the engine. I seem to remember that it goes somewhere behind the engine. I think when I was putting the engine in, I noticed part of the harness hanging near the firewall so I disconnected this connector, but I looked all over and can't find the mating connector. any ideas, or where it goes? Thanks
|
|
|
|
03-07-2017, 11:28 PM
|
#2 |
|
Registered User
Join Date: Mar 2001
Location: Houston, tx
Posts: 141
|
Re: Help needed for new rebuild and unknown connector
Ok, I found it. It bolts to the firewall and hooks to the connector on the hood.
|
|
|
|
|
03-08-2017, 08:43 AM
|
#3 |
|
Registered Truck Offender
Join Date: May 2008
Location: hells training ground (aka Ariz)
Posts: 3,118
|
Re: Help needed for new rebuild and unknown connector
Hahaha Don't you hate that. One stray connector in the engine harness that just doesn't go anywhere,, then you find out it DOESNT even go to the engine. I've beat my head agaist this rock so many times it's not even funny.
__________________
Still playin with trucks, even at my age! When you're dead, it's only a problem for the people around you, because you don't know you're dead. .....It's kinda the same when your STUPID. I just did my taxes and reviewed my SS statement. Thanks to the current administration it looks like I will only have to work till noon on the day of my funeral. |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
