|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
01-06-2014, 02:54 PM
|
#1 |
|
Senior Member
 
Join Date: Jan 2012
Location: Phoenix, Arizona
Posts: 498
|
Question about trailing arms
I just got mine off and cleaned them up. Its a wonderr they all don't break. Now the split in the middle of them should i seal that. also the piece that is spot welded on has some areas that are pulling apart, can i clean up under them and reweld or not. pics to follow. Thanks nick
|
|
|
|
01-06-2014, 04:32 PM
|
#2 |
|
1965 Chevy C10, 2005 4.8L/4l60
Join Date: Aug 2004
Location: DFW Texas
Posts: 8,540
|
Re: Question about trailing arms
maybe bite the bullet and get some tubular ones, is your truck a driver or a show truck?
__________________
Clyde65 Rebuild of Clyde http://67-72chevytrucks.com/vboard/s...84#post8338184 69 Aristocrat Lo Liner build http://67-72chevytrucks.com/vboard/s...84#post7561684  support our troops! |
|
|
|
|
01-06-2014, 07:03 PM
|
#3 |
|
Senior Member
Join Date: Jan 2012
Location: Phoenix, Arizona
Posts: 498
|
Re: Question about trailing arms
Dd
|
|
|
|
|
01-06-2014, 07:28 PM
|
#4 |
|
Registered User
Join Date: Apr 2001
Location: DALLAS,TX
Posts: 21,919
|
Re: Question about trailing arms
You can run short 1-2" beads down the center seam if there's no significant rust or scaling for peace of mind.
__________________
67SWB-B.B.RetroRod 64SWB-Recycle 89CCDually-Driver/Tow Truck 99CCSWB Driver All Fleetsides @rattlecankustoms in IG Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive. It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar..... Cubic inches is like Indiana Jones with a cheap pistol. |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
