|
02-09-2014, 08:36 PM
|
#1 |
|
Senior Member
 
Join Date: Mar 2012
Location: Chesapeake, Va
Posts: 1,275
|
trans case question
well i tore down my TH350 today, in the back section where the (output planet assembly) main piston sets my case is eroded/pitted where the bottom O ring seals not allowing the o ring to seal and it wore a chuck out of old o ring. is it possible to fill the erosion/pitting or do i need to get a another case.
do tranny supply shops sell new cases or should i find a old core at a junk yard?
__________________
Mike 72 C-10 Cheyenne off frame resto and Upgraded to 4 wheel disk, Tilt, Dakota Digital Dash / Rear slider. 421 SBC / TH350 3000RPM Stall Progression Ignition /Holley 750 DP/3:73 gear Eaton Limited Slip unit / 2 1/2 exhaust glasspacks 
|
|
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
