|
07-27-2004, 09:50 PM
|
#1 |
|
Registered User
Join Date: Jul 2004
Posts: 37
|
need help bad
Hello i need help bad i have a 70 half ton took the bed off to sand blast the frame and hooked up a pair of tail lights so i can drive it,
 here is were the problem starts when i hit the brakes no lights i have to get on them hard to get any lights and then the left turn signal comes on i also have no turn signals at all and no braks lights when my head lights are on were did i screw up at thanks for lettin me ramble thanks shannon
|
|
|
|
07-27-2004, 09:56 PM
|
#2 |
|
Watch out for your cornhole !
 
Join Date: Jun 2003
Location: Azle, Texas
Posts: 14,162
|
Your temporary taillight housings are not grounded properly to the truck. Add a short ground wire if you need to.
__________________
I'm on the Instagram- @Gearhead_Kevin |
|
|
|
|
07-28-2004, 06:26 AM
|
#3 |
|
Senior Member
Join Date: Jul 2001
Location: Muskegon,MI,USA
Posts: 6,026
|
Welcome to the board from West Michigan!
Good luck on your problem, Tx Firefighter is probably right about the ground problem. Jim |
|
|
|
|
07-28-2004, 07:47 PM
|
#4 |
|
Registered User
Join Date: Jul 2003
Location: north of Phx AZ about 30 miles
Posts: 698
|
Ditto on the ground, assuming everything worked right before hand.
__________________
Andy,Phx AZ '67 C-10 (Ahhh, done at last. Well there is that disk front end I want to put in and...) "23 C-Cab-sold '48 Ford 8N tractor(still working) '67 Scout(Now on the road) '70 MG B.-sold |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
