Adapter bracket for clutch linkage on sm465 to ls6.0

[weedoublewide]

I can't remember whom or where I saw it, but there is an adapter bracket out there for mounting the mechanical clutch assembly to the block/bellhousing of the LS 6.0 when its mated to the sm 465.

I could build one but I'm going to take the lazy route and just buy it LOL.

If anyone knows of any leads or has used one, I'd appreciate the help.

Thank you and best regards,

double

[mongocanfly]

This bracket should work...it says nv4500 but all it does it provide a threaded hole for the pivot ball...
I used one one my 6.0/nv4500 swap.....https://www.summitracing.com/parts/a...UaAj_tEALw_wcB
It uses the 2 bolts on the bellhousing to mount..the brace goes back to one of the trans mount holes..

[weedoublewide]

Originally Posted by mongocanfly

This bracket should work...it says nv4500 but all it does it provide a threaded hole for the pivot ball...
I used one one my 6.0/nv4500 swap.....https://www.summitracing.com/parts/a...UaAj_tEALw_wcB
It uses the 2 bolts on the bellhousing to mount..the brace goes back to one of the trans mount holes..

Wonderful, thank you again mongo

Best regards,

double