|
02-23-2009, 10:49 AM
|
#1 |
|
Registered User
Join Date: Mar 2007
Location: south carolina
Posts: 247
|
Bed Strips
My original bed sides have 9 holes ,Do the bed strips have this many also? What are the measurements for each hole? ('56 short step)
|
|
|
|
02-23-2009, 12:24 PM
|
#2 |
|
Registered User
Join Date: Feb 2005
Location: location
Posts: 527
|
Re: Bed Strips
Most of the suppliers will have pre-drilled bed strips for your truck. I would not recommend drilling your own as they are square to accomodate the carriage style bolts.
|
|
|
|
|
02-23-2009, 07:05 PM
|
#3 |
|
Registered User
Join Date: Mar 2007
Location: south carolina
Posts: 247
|
Re: Bed Strips
MAR-K makes angle covers without holes,They make ribbed bolts to replace the carrige bolts.
|
|
|
|
|
02-24-2009, 01:06 AM
|
#4 |
|
Registered User
Join Date: Jun 2006
Location: Idaho
Posts: 8,800
|
Re: Bed Strips
Mar-K has pretty good photos and you can count the bolt holes in the strips. I didn't notice if they have the spacing. The factory assembly manual show the bed strip holes lining up with the side angle holes but does not give the spacing, the parts must have arrived pre punched so it was not a critical dimension.
__________________
1959 Chevy Short Fleetside w/ 74 4WD drive train (current project) OrrieG Build Thread 1964 Chevelle Malibu w/ 355-350TH (daily driver) Helpful AD and TF Manual Site Old Car Manual Project Last edited by OrrieG; 02-24-2009 at 01:10 AM. |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
