The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > 47 - Current classic GM Trucks > The 99-06 Chevy and GMC Message Board

Web 67-72chevytrucks.com


Reply
 
Thread Tools Display Modes
Old 01-03-2018, 06:45 AM   #1
bikernut
Registered User
 
bikernut's Avatar
 
Join Date: Jan 2008
Location: Soutwestern New Hampshire
Posts: 135
check engine light

on my daughters 2001 GMC Yukon XL with 5.3 engine she went in for the annual state inspection and just before getting there the check engine light started glowing. of course it failed the inspection and they gave here a temporary one for 2 extra months. well being a single mother she couldn't afford to do this right away so after 4 months she finally could afford it and had it done. now the question is she was told she had to put 100 miles on it to cancel out the code as just clearing it wouldn't work. if she drives in now with an expired inspection ticket she get fined for driving an uninspected vehicle. now is there a way to get the code canceled out with out driving it for 100 miles and risking a ticket. thanks
__________________
2016 GMC Denali 3500, 4x4, crew cab, long bed, Duramax with Allison trans, (Dark Garnet Metallic)
2003 GMC 3500 4X4 Dually Dump (Red)
2007 KZ 41KG Toy Hauler (White with stripes)
2015 Harley FLHTCUTG Trike ( Maroon)
1995 Harley FLT (2 tone Red)

Last edited by bikernut; 01-03-2018 at 07:00 AM.
bikernut is offline   Reply With Quote
Old 01-03-2018, 06:05 PM   #2
homemade87
Registered User
 
Join Date: Apr 2010
Location: Guntersville Alabama
Posts: 932
Re: check engine light

That's a load of crap . Any shop that has the capability can clear the code . Apparently that shop does not . They just told her that because they could not do it .

That being said if a problem has been solved ( I hope they did fix it )after so many key cycles the code will clear ( this is there reason for the 100 miles ) . This is in place in case a temporary problem show up . It will clear itself .

One solution to your problem is take it to one of your local auto chain stores . They will read your code for you but will not clear it . They will hand you the reader for you to clear . Liability reasons . You may want to go with her to get this done .
homemade87 is offline   Reply With Quote
Old 01-03-2018, 07:00 PM   #3
greasemonkey
Registered User
 
greasemonkey's Avatar
 
Join Date: Dec 2001
Location: Pace, FL
Posts: 2,049
Re: check engine light

Code readers can be had on the cheap, I think I used a discount and got one at Advance for $50 or so. Handy little thing. It reads and clears codes. I find it hard to believe that a shop with the ability to fix a car would not have a basic code reader. How would they even know if it was fixed and the code wasn't still active?
Assuming the problem has actually been fixed, you can pull the negative battery cable to clear the code too. I used to do this after getting a code read and fixed but didn't have a scanner. Stores here won't let you clear it with their scanner, maybe you would have better luck.
greasemonkey is offline   Reply With Quote
Old 01-04-2018, 10:14 AM   #4
95 S_Trucker
Senior Member
 
95 S_Trucker's Avatar
 
Join Date: Oct 2009
Location: Lancaster, PA
Posts: 1,757
Re: check engine light

She has to drive it to set readiness monitors.

Readiness monitors are the self tests the car does as it drives down the the road(Cat, EVAP, EGR, AIR, O2 sensor/heater).

When the codes are cleared, the readiness monitors are also cleared.

In states that have OBD emission testing, A car will not pass if a certain amount of the readiness monitors aren't set(depends on vehicle year and state)

It's hard to say if the shop is at fault for using bad terminolgy, or if it got lost in translation(she said he said). But the car will need driven a minimum of 30 miles before most of the readiness monitors are set. A little but of stop and go, and a little bit of cruising at 55(drive it like an old man, no sudden starts or stops).

I own a PA inspection/emission station.
__________________
-99 K2500 LS CCSB 7.4
-96 C3500 HD 7.4 NV4500 Rollback
-85 K10 5.7 700r4
-78 K10 5.7 4 Speed
-90 ZR1 5.7 6 Speed
-62 Lincoln Sedan 430 Auto
-61 Lincoln Convertable, 430 Auto


85 Project: http://67-72chevytrucks.com/vboard/s...d.php?t=368864

78 Big10 Project: http://67-72chevytrucks.com/vboard/s...d.php?t=383629

96 Project: http://67-72chevytrucks.com/vboard/s...d.php?t=614515
95 S_Trucker is offline   Reply With Quote
Old 01-04-2018, 02:04 PM   #5
greasemonkey
Registered User
 
greasemonkey's Avatar
 
Join Date: Dec 2001
Location: Pace, FL
Posts: 2,049
Re: check engine light

That is great info. Should the shop have cleared the code and told her to drive the 100 miles, or does it make sense to leave the code and let it clear itself?
__________________
1942 Master Deluxe
1969 C/10
1985 Blazer CUCV
1987 Jimmy
2004 Tahoe
2005 Silverado
greasemonkey is offline   Reply With Quote
Reply

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 05:31 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2018, vBulletin Solutions, Inc.
Copyright 1997-2013 67-72chevytrucks.com