07-06-2017, 10:45 PM | #1 |
Registered User
Join Date: Oct 2015
Location: BAKERSFIELD
Posts: 36
|
Window regulater
Any one replaced a window regulater on a front door 3500 2000 one ton truck how hard a job
|
07-15-2017, 02:57 PM | #2 |
Registered User
Join Date: Dec 2013
Location: Canada
Posts: 35
|
Re: Window regulater
Hey, Ive done it a couple times with both electric and manual crank windows, its not that the job is hard, but it can be annoying to set the rollers back into the tracks while having the inner door panel dangling. You will need to drill out the old regulator rivets/pressed fasteners and simply replace the rivets or use bolts (recommended bolts). grease it up with some new grease and clean your connections, should work great!
this may be obvious to some people but I found out the hard way not to remove the regulator motor housing, the brushes inside are NON replaceable and are very brittle. so I would recommend stayin away from that. Edit: additional you will have to have power to the window to move it into the tracks, or if you have a manual crank you will need that attached to roll it up and down, again probably obvious but just trying to be thorough. Last edited by xKid4x4s; 07-15-2017 at 02:59 PM. Reason: Required more information |
07-24-2017, 11:11 AM | #3 |
Registered User
Join Date: Oct 2015
Location: BAKERSFIELD
Posts: 36
|
Re: Window regulater
Thanks for the info ron
|
Bookmarks |
Thread Tools | |
Display Modes | |
|
|