Need some frame expert help

[Jeff's72C10*]

I think I posted a pic of the damage of the front frame cross member on a truck I purchased a while back. I have a friend who has an early 80's frame that the cross member is in excellent condition. He says the frames are the same from 67 to the early 80's as far as the front section is. Can anyone verify that this would work on my 72? Appreciate any help. Photo of my damaged one for reference. Thanks again

[notsolo]

You may opt for swapping out the whole front cross member, axle hub to hub, cross members fit thru "87"...That's what's under my "72" works fine.

[Jeff's72C10*]

Originally Posted by notsolo

You may opt for swapping out the whole front cross member, axle hub to hub, cross members fit thru "87"...That's what's under my "72" works fine.

Thank you, appreciate the info. He's giving me the whole frame. I can't use it except for parts as it's a shortbed frame and I have a long bed. It does have a 12 bolt posi rear end, disc brakes on the front and a set of the rallye wheels, so that's a plus. I'll probably swap the whole thing, but replace the bushings and such first.

I would imagine to swap the front cross member the engine will either need to come out or some way be supported? Thx again

[KQQL IT]

Be easier with the engine out.
Could also use the clamshell style motor mounts as well.

[LockDoc]

Originally Posted by Jeff's72C10*

Thank you, appreciate the info. He's giving me the whole frame. I can't use it except for parts as it's a shortbed frame and I have a long bed. It does have a 12 bolt posi rear end, disc brakes on the front and a set of the rallye wheels, so that's a plus. I'll probably swap the whole thing, but replace the bushings and such first.

I would imagine to swap the front cross member the engine will either need to come out or some way be supported? Thx again

I just jacked my engine up and blocked it while I swapped the entire cross member on one of my trucks. I had to re-drill one hole on each side and enlarge one hole on each side. I think the front cross member is the only assembly that will swap in with a minimum of modifications.

LockDoc

[Jeff's72C10*]

Originally Posted by LockDoc

I just jacked my engine up and blocked it while I swapped the entire cross member on one of my trucks. I had to re-drill one hole on each side and enlarge one hole on each side.

LockDoc

Thank you sir for the additional info. Appreciate it.