The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > General Truck Forums > Engine & Drivetrain

Web 67-72chevytrucks.com


 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 03-11-2018, 06:06 PM   #1
Pinchecharlie
Registered User
 
Join Date: Apr 2017
Location: Bozeman
Posts: 201
Coolant in pan questions

So I had a bad manifold install and after buttoning up that and trying to find where the oil mess was coming from. I decided to drain the pan and check the rear main. Well the first 2 seconds of fluid was coolant , then crap oil. So it's been awhile since I was a master mechanic (like never) so coolant in oil= bad head gasket, bad maiffold gasket or cracked head/s and or block right? Just want to have a plan of attack. Where do sbc 350 usually blow head gaskets? I know the ma ifold job was crap and that it was the rear rail that was not sealed could that lead coolant to oil? My csi Miami engine skills are low. Any insight before i dig in? Coolant was fresh, back of block and drivers side by filter was very oily and top of bellhousing was cacked with oil. Thanks your insights ,your humble forum member charlie
Pinchecharlie is offline   Reply With Quote
 

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 06:13 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2018, vBulletin Solutions Inc.
Copyright 1997-2013 67-72chevytrucks.com