The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > Info Center > FAQ Truck Tech > 60-66

Web 67-72chevytrucks.com


Closed Thread
 
Thread Tools Display Modes
Old 04-20-2011, 10:12 AM   #1
lakeroadster
Account Suspended
 
Join Date: Sep 2009
Location: High Plains of Colorado
Posts: 2,485
Cab panel - missing clip solution

I didn't have the clip. The trim panels have a formed lip that curls under around their perimeter. We will use pan head stainless sheet metal screws in leu of the clip:

What I did:
  1. Use Scotch blue masking tape to cover the paint on the area where the trim panels contact the cab.
  2. Set the panels on the cab and trace the outline of the panel.
  3. Measure the width of the lip and transfer it to the masking tape.
  4. Measure the diameter of the shank of the screw. I used #10. Take the shank diameter and divide it by 2 and then offset the line in step 3 by that amount.
  5. Drill (2) of the appropriate size holes in the approximate area of where the clip originally went. (see sketch below)
  6. Install the pan head stainless sheet metal screws but back them off such that the formed lip on the trim panel slips snugly under the screw head.
  7. Test fit the panel. Keep adjusting the screws until the panel is snug.
  8. Remove masking tape.
  9. Install remaining OEM fasteners into trim.
  10. Stand back and enjoy.

Last edited by augie; 04-21-2011 at 12:22 PM.
lakeroadster is offline  
Closed Thread

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 03:01 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2018, vBulletin Solutions Inc.
Copyright 1997-2013 67-72chevytrucks.com