|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
01-10-2005, 08:16 PM
|
#1 |
|
Senior Member
Join Date: Oct 2004
Location: calhoun city ms
Posts: 940
|
Front suspension torque specs?
hey guys, i want to reassemble my front suspension this weekend and was wondering could anybody point the way for torque specs for the upper and lower balljoints, inner and outter tie rods and idler arm. it is a 70 2wd with manual steering.
really want to do this the correct way if at all possible. thanks for your help.
__________________
ongoing 1970 c 10 lwb  1994 z-28 few mods.-owned since new  1978 vette silver/grey 25th anniv. paint 
|
|
|
|
01-11-2005, 09:41 PM
|
#2 |
|
Join Date: Dec 1999
Location: Eastern - Manitoba Canada, Winnipeg
Posts: 4,369
|
upper ball joint nut 50 ft lbs
lower ball joint nut 90 ft lbs tie rod ball joint nut 30 ft lbs tie rod clamp bolts 132 inch lbs idler arm mounting bolts 30 ft lbs idler arm to relay rod nut 60 ft lbs pitman arm to relay rod nut 60 ft lbs all from a 71 c10 spec sheet ...should be same as 70 I dont visit this section too often
__________________
Senior active founding member. 70 3/4 ton GMC Suburban 4x4 250/4 spd. 71 1/2 ton Suburban Chevy 4x4, 350/350 72 Chev 1 ton tow truck 402BB w/Holmes 440 wrecker on propane 2005 FLSTSCI Harley Springer 85 FXSB Harley Lowrider 72 Triumph 650 Bonneville 5spd "Poor people don't have hobbies" Quote from wife. |
|
|
|
|
08-30-2019, 09:03 PM
|
#3 | |
|
Registered User
Join Date: Oct 2018
Location: Lake Mills, WI
Posts: 4
|
Quote:
Posted via Mobile Device |
|
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
