Depinned engine harness --- now ... ?? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

FAKKY · 03-10-2019, 01:05 PM

So unloomed and depinned this bad boy about 6+ months back.
Now looking to finish it off and get it into they truck.

Whats the best approach here ? Stuff like ....

Routing and lengthening/shortening wires ..... which ones typically ..... injectors seem to be a standout as they are in completely different positions. eg first part of harness from the PCM .... .annd then about smack bang in middle of the middle run.

Grounds - how many should there be ? Where do they connect (Harness was removed by a friend whilst I was dissaembling the trans).

Other suggestions ?

This a 2007 lq4 6.0.

03-10-2019, 01:05 PM	#1
FAKKY Registered User Join Date: Sep 2016 Location: Redington Beach Posts: 1,312	Depinned engine harness --- now ... ?? So unloomed and depinned this bad boy about 6+ months back. Now looking to finish it off and get it into they truck. Whats the best approach here ? Stuff like .... Routing and lengthening/shortening wires ..... which ones typically ..... injectors seem to be a standout as they are in completely different positions. eg first part of harness from the PCM .... .annd then about smack bang in middle of the middle run. Grounds - how many should there be ? Where do they connect (Harness was removed by a friend whilst I was dissaembling the trans). Other suggestions ? This a 2007 lq4 6.0. __________________ FAKKY 57 PANEL BUILD Last edited by FAKKY; 03-10-2019 at 01:12 PM.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.