Changing 4WD 69 blazer to 2WD - The 1947 - Present Chevrolet & GMC Truck Message Board Network

wytnuklryd · 02-05-2003, 02:36 PM

This is a project I am currently undertaking and I was wanting any advice from someone who has done this before.

69 K-Blazer 1/2 ton 73-87 5 lug suspension with disc brake and lowered spindle (bell tech)

Thank's in advance,
Sam

brad2 · 02-06-2003, 10:14 PM

My understanding is that it is fairly straight forward. The crossmember is close to a bolt in affair. Most likely you'll need to flip the rearend on top of the leafs. It has been done many times before. You might get a better response on the main 67-72 board. Or you could drive over to Oklahoma and get my complete chassis and put your tub on it.

blazer boy · 02-07-2003, 01:42 PM

i have done this swap on my 69 . i used a 74 truck crossmember and associated parts . on the rear i am going with a ladder bar set up . i used belltech drop spindles with firestone airbags on the front . with the air let out of the bags , it will lay the control arms on the pavement. with a 235/60/15 tire .

02-05-2003, 02:36 PM	#1
wytnuklryd Registered User Join Date: Jan 2003 Location: Tempe, AZ Posts: 6	Changing 4WD 69 blazer to 2WD This is a project I am currently undertaking and I was wanting any advice from someone who has done this before. 69 K-Blazer 1/2 ton 73-87 5 lug suspension with disc brake and lowered spindle (bell tech) Thank's in advance, Sam

02-06-2003, 10:14 PM	#2
brad2 Registered User Join Date: Feb 2001 Location: edmond, ok Posts: 1,058	My understanding is that it is fairly straight forward. The crossmember is close to a bolt in affair. Most likely you'll need to flip the rearend on top of the leafs. It has been done many times before. You might get a better response on the main 67-72 board. Or you could drive over to Oklahoma and get my complete chassis and put your tub on it.

02-07-2003, 01:42 PM	#3
blazer boy Registered User Join Date: Feb 2001 Location: derby ks usa Posts: 115	i have done this swap on my 69 . i used a 74 truck crossmember and associated parts . on the rear i am going with a ladder bar set up . i used belltech drop spindles with firestone airbags on the front . with the air let out of the bags , it will lay the control arms on the pavement. with a 235/60/15 tire .



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.