|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
04-26-2013, 03:13 PM
|
#1 |
|
Registered User
Join Date: Jul 2009
Location: hebron, ohio
Posts: 91
|
1968 Dana 44 lockout hub?
My question is i am looking at replacing my 1968 k20 closed knuckle axle with a 74 k20 dana 44 open knuckle with full time hubs. would my warn lockout on the closed knuckle be able to swap over?
|
|
|
|
04-26-2013, 07:25 PM
|
#2 |
|
Senior Member
 
Join Date: Apr 2012
Location: Otway OH
Posts: 786
|
Re: 1968 Dana 44 lockout hub?
Where in the heck is Hebron?
|
|
|
|
|
04-26-2013, 07:26 PM
|
#3 |
|
Senior Member
Join Date: Mar 2003
Location: Colfax-California
Posts: 8,393
|
Re: 1968 Dana 44 lockout hub?
K20, maaaaaybe, can you post up a pic of the 68 hub?
|
|
|
|
|
04-27-2013, 09:27 AM
|
#4 | ||
|
just can't cover up my redneck
Join Date: May 2004
Location: Columbus OH
Posts: 11,414
|
Re: 1968 Dana 44 lockout hub?
Quote:
 It is kind of funny that there are two of you from such a small town on here.
__________________
You can review the site's rules here. Quote:
Bad planning on your part does not necessarily constitute an instant emergency on my part.... The great thing about being a pessimist is that you are either pleasantly surprised or right.
|
||
|
|
|
|
04-28-2013, 03:06 PM
|
#5 | |
|
Registered User
Join Date: Nov 2005
Location: Midland Michigan
Posts: 5
|
Re: 1968 Dana 44 lockout hub?
Quote:
Your 68 closed knuckled HD 44 front axle will be of the EXTERNAL HUB design, and your 74 K20 front axle should except these hubs with no problems at all. GM used the Heavy Duty Dana 44 front axle from the 1960's till early 1977. ALL used the external bolt on hubs, or drive flanges. To be safe, post a pic of the 68 and 74 hubs, just to make sure somebody hasnt swapped out either axle and replaced it with something other than what came from the factory when either truck was brand new. |
|
|
|
|
|
05-01-2013, 11:11 PM
|
#6 |
|
Registered User
Join Date: Mar 2010
Location: Minneapolis Minnesota
Posts: 70
|
Re: 1968 Dana 44 lockout hub?
I have same truck...Are you saying I can keep the old Warn lockouts in the new 74K20 axle?? That would be great if so???
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
