|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
04-22-2018, 10:10 PM
|
#1 |
|
Registered User
Join Date: Jul 2011
Location: El Campo, Tx
Posts: 13
|
67 Rear wheel backspacing
67 fleetsidewith original rear end. Will a 10 inch wheel with 4 1/2 inch backspacing fit?
|
|
|
|
04-23-2018, 09:48 AM
|
#2 |
|
Senior Member
 
Join Date: Jun 2014
Location: Mocksville, NC
Posts: 1,723
|
Re: 67 Rear wheel backspacing
Yes but clearance will be tight on the outer fender. I have the equivalent of this (9" wheel, 3.5" bs) and I have about 1/2" clearance between tire and outer fender. This is also after removing the outer half of the inner fender to gain more clearance. If you lower your truck at all with that wheel it will most likely rub on the outside.
__________________
Builds: Green Gus the 68 C10 ; Sullii the 72 1500 - Instagram: @dr.hewitt - C10 Concept/Development Photos: Master Thread |
|
|
|
|
04-24-2018, 07:30 PM
|
#3 |
|
Senior Member
 
Join Date: Jan 2011
Location: Chattanooga TN
Posts: 6,205
|
Re: 67 Rear wheel backspacing
Step or Fleetside ? -- Edit ** Oh, NM.
10" wheel, 5" Backspacing. 67-68 Original narrow(er) housing length. Dropped about 7". 295/45 tire. 4 1/2" BS would be tight.
__________________
Chad 1967 C10 SWB - Project Savannah - 6.0/4L80 *Currently underway* 1968 C10 SWB - TOTY 2018, 50th Anniversary Tribute Project * Sold * Pride and Joy 1986 Silverado Short Fleet - Scarlet *Sold* 1985 Silverado Short Fleet *Sold* 2022 Jeep Gladiator Mojave 2001 Jeep Cherokee XJ 4x4 - Lifted, Built 1992 Jeep Cherokee XJ 4x4 - Lifted 2013 Honda Accord EX-L v6 Coupe 6spd (wife's ride) |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
