The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > Info Center > FAQ Truck Tech > 60-66

Web 67-72chevytrucks.com


Closed Thread
 
Thread Tools Display Modes
Old 01-27-2012, 03:59 PM   #1
GMR-PERFORMANCE
Registered User
 
GMR-PERFORMANCE's Avatar
 
Join Date: Aug 2010
Location: Keller TX
Posts: 836
How to replace window rollers

To read the original thread and discussion on this topic go here- LINK


This is a DIY deal. I bought the rollers and pins from classic chevy. I installed one using there new pin. I did not like how it mushroomed over. Thus I ground it off and used the OEM pins and the new rollers. I ground down the staked side and , used a square face punch. I installed the new roller , tapped the new set up back into the arm and hit it very quicly with the mig. Then used a bit of water to cool the part down to prevent the roller from melting. It took me less than 10 minutes to do all them this way. Just thought it would be a nice post.
Attached Images
     

Last edited by augie; 05-09-2012 at 01:07 AM.
GMR-PERFORMANCE is offline  
Closed Thread

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 06:23 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com