The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > General Truck Forums > Suspension

Web 67-72chevytrucks.com


Reply
 
Thread Tools Display Modes
Old 04-21-2011, 09:24 PM   #1
texastrendz
Registered User
 
Join Date: Jan 2008
Location: HOUSTON TX
Posts: 1,161
sway bar ?

i am installing nate's sway bar kit on my 72 with a dropmember and factory 73-87 a arms. my question is the sway bar is close to the rack and pinion setup, it is about 2 inches from touching at ride height and is this safe? it will fully cycle without touching. just gets close at some points when traveling the full cycle.
Attached Images
   
texastrendz is offline   Reply With Quote
Old 04-22-2011, 01:12 AM   #2
PBFAB.COM
Senior Member
 
PBFAB.COM's Avatar
 
Join Date: Dec 2003
Location: Mesa,Az
Posts: 3,981
Re: sway bar ?

Quote:
Originally Posted by texastrendz View Post
i am installing nate's sway bar kit on my 72 with a dropmember and factory 73-87 a arms. my question is the sway bar is close to the rack and pinion setup, it is about 2 inches from touching at ride height and is this safe? it will fully cycle without touching. just gets close at some points when traveling the full cycle.
Yes it is safe... and when you get the other tabs I am making for your factory arms it will give you a little more room. The little angle ones you have in the pics set the bar a little higher.
__________________
www.PorterbuiltFabrication.com

Phone: 480-297-2621

E-mail: sales@pbfab.com


Find us on FaceBook under Porterbuilt Fabrication

Specializing in Chassis and Suspension Components for your Classic Chevrolet Truck.

We offer components from the following manufacturers:

Porterbuilt
Accuair
Ridetech (Air Ride Technologies)
Air Lift
Wilwood
Intro
Unisteer
ECE
Gotta Show
Air Lift
Borgeson
CPP


Supporting this forum since 2003!
PBFAB.COM is offline   Reply With Quote
Old 04-22-2011, 10:43 AM   #3
texastrendz
Registered User
 
Join Date: Jan 2008
Location: HOUSTON TX
Posts: 1,161
Re: sway bar ?

hey nathan thanks for the response. i was expecting the new tabs to be the same dimensions with a porterbuilt twist. i will hold off drilling any hole until i see the new brackets. thanks again, Daniel.
texastrendz is offline   Reply With Quote
Reply

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 06:47 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com