|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
05-02-2017, 08:22 PM
|
#1 |
|
Senior Member
 
Join Date: Jan 2016
Location: Enumclaw WA
Posts: 267
|
Part identification help
Anyone know what this is? Was bolted to the bottom of the drivers side frame on a 1972 Jimmy. Thanks
|
|
|
|
05-02-2017, 09:07 PM
|
#2 |
|
Senior Member
Join Date: Jan 2001
Location: Orem, Utah
Posts: 7,794
|
Re: Part identification help
In 1971 and 72 4WD trucks got those to keep the leaf spring from coming through the floor pan in a front end collision.
|
|
|
|
05-02-2017, 09:12 PM
|
#3 |
|
Senior Member
Join Date: Jan 2016
Location: Enumclaw WA
Posts: 267
|
Re: Part identification help
Thanks
|
|
|
|
|
05-03-2017, 08:24 AM
|
#4 |
|
Senior Member
Join Date: May 2011
Location: Greencastle PA
Posts: 6,708
|
Re: Part identification help
Bolts to the drivers side bottom of the frame. LOL just realized you knew that already.
|
|
|
|
|
05-03-2017, 12:33 PM
|
#5 |
|
Registered User
Join Date: Feb 2003
Location: Santa Ana, CA
Posts: 2,191
|
Re: Part identification help
Just a side note - if you are running the stock front springs with the inverted arch, it is probably good to keep this piece in place. When compressed, the inverted springs pull the rear shackles forward, away from the bracket. However, if you are running lift springs that have a downward arch, you will want to get rid of the bracket. When compressed, the lift springs will push the rear shackles towards the bracket and hit it. This will prevent the driver side spring from fully compressing and will cause a "thunk" noise when the spring eye hits the bracket.
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
