Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
01-19-2019, 11:10 AM | #1 |
Registered User
Join Date: Jun 2018
Location: Port Byron IL
Posts: 47
|
Electrical Question (accessories)
I ran into a snag while wanting to wire up all of my accessories. I simply do not have enough Keyed ignition sources for what I want to operate since my LS swap.
My harness is an aftermarket unit but it only has 2 ignition sources. Those are currently occupied by the computer. I need the following: Computer Air bag compressors (2) Wideband 02 Several gauges What alternative do I have here? Can I get a fused ignition bar like this?https://www.speedwaymotors.com/Speed...xoCFdcQAvD_BwE If so How would I hook it up to be "Keyed ignition" Any help is appreciated |
01-19-2019, 09:16 PM | #2 |
Registered User
Join Date: Dec 2013
Location: Dunwoody,Ga
Posts: 443
|
Re: Electrical Question (accessories)
I have a similar fuse holder from Summit. I plan to run one switched 12v piggy backed of an existing fuse to a relay that has amperage enough to handle the needed load. The relay would draw very low current and shouldn't blow the fuse.
|
01-19-2019, 10:11 PM | #3 |
Registered User
Join Date: Jun 2013
Location: Somewhere
Posts: 3,052
|
Re: Electrical Question (accessories)
You can install a junction block off a keyed source, or a relay controlled keyed source to provide ans much power as is available from the battery, which is in vehicle term, infinite.
|
Bookmarks |
Thread Tools | |
Display Modes | |
|
|