|
09-20-2022, 08:44 AM
|
#1 |
|
Senior Member
  
Join Date: Jan 2002
Location: Burghill, Ohio 44404
Posts: 3,400
|
Ball joint sleeve 4x4
How far does the upper ball joint go in on front axle.
__________________
  1972 GMC Jimmy 1/2 4X4 4wheel camper 1970 GMC Jimmy 1/2 4X4 350 1969 Chevy Blazer 1/2 4X4 307 1967 chevy LWB 3/4 396 |
|
|
|
09-20-2022, 08:58 AM
|
#2 |
|
Registered User
Join Date: Feb 2000
Location: Maquoketa, Ia/ Orr, Mn
Posts: 2,966
|
Re: Ball joint sleeve 4x4
It doesn't go in a certain depth. You need to install the knuckle with new balljoints first, torque the bottom ball joint nut to spec, then you thread the adjusting sleeve down and torque that to spec on the upper ball joint and then install the upper ball joint nut. This is a snap shot from the Moog installation instructions.
__________________
'51 South Bend Model "9A" '56 Chevy 3600 NAPCO '74 Chevy Cheyenne Super K20-restored on 37's '72 GMC Sierra Custom K2500- in progress '08 GMC Envoy Denali '12 GMC Sierra 2500HD Denali '17 GMC Yukon XL VCCA member #58596 http://www.nohrco.com |
|
|
|
|
09-20-2022, 09:13 AM
|
#3 |
|
Senior Member
Join Date: Jan 2002
Location: Burghill, Ohio 44404
Posts: 3,400
|
Re: Ball joint sleeve 4x4
Ok thanks I thought I had to put it in first at 70 which doesn't work.
__________________
1972 GMC Jimmy 1/2 4X4 4wheel camper 1970 GMC Jimmy 1/2 4X4 350 1969 Chevy Blazer 1/2 4X4 307 1967 chevy LWB 3/4 396 |
|
|
|
|
09-20-2022, 11:38 AM
|
#4 |
|
Senior Member
Join Date: Mar 2003
Location: Colfax-California
Posts: 8,393
|
Re: Ball joint sleeve 4x4
My Spicer book says 50 on the castle nut. Then 95-100 on the top nut while lining up the cotter pin slot
|
|
|
|
|
09-20-2022, 01:02 PM
|
#5 |
|
Registered User
Join Date: Feb 2000
Location: Maquoketa, Ia/ Orr, Mn
Posts: 2,966
|
Re: Ball joint sleeve 4x4
Heres the procedure from the 1971 truck service manual.
Lower balljoint nut to 70 ftlbs adjusting sleeve to 50 ft lbs Upper balljoint nut to 100 ft lbs- apply additional torque to align cotter pin hole
__________________
'51 South Bend Model "9A" '56 Chevy 3600 NAPCO '74 Chevy Cheyenne Super K20-restored on 37's '72 GMC Sierra Custom K2500- in progress '08 GMC Envoy Denali '12 GMC Sierra 2500HD Denali '17 GMC Yukon XL VCCA member #58596 http://www.nohrco.com |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
