The 1947 - Present Chevrolet & GMC Truck Message Board Network

Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > General Truck Forums > Electrical


Thread Tools Display Modes
Old 05-12-2019, 02:52 PM   #26
Registered User
Join Date: Sep 2018
Location: Redding, Calif.
Posts: 48
Re: ignition coil resistor

Everything on this wiring harness goes through the ECU and then to the starter. There will be a large cable going to the positive side of the starter and the connection is already made from harness to plug in terminal on the starter.
I only have 12 volt constant (pink) red to purple, trans wire to brake, green to rad fan assembly, and a ground to hook up on this harness.
Once I hook up positive wire from battery to alternator, the ECU will have constant power and the pink wire is basically my RUN wire and is used to turn engine off.
Mitch from has a good video of how these harnesses work.
howell57 is offline   Reply With Quote


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -4. The time now is 08:36 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2019, vBulletin Solutions Inc.
Copyright 1997-2013