The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > Info Center > FAQ Truck Tech

Web 67-72chevytrucks.com


 
 
Thread Tools Display Modes
Old 01-25-2014, 04:47 PM   #1
mattcrp1
Registered User
 
mattcrp1's Avatar
 
Join Date: May 2010
Location: Mountain House, CA
Posts: 555
FAQ - Rebuilding Calipers

Hi all I thought I would post my caliper rebuild. I found that a rebuild kit was only three dollars. I wasnt trying to be cheap, but I dont have a lot of extra cash. I started by removing the piston,**DO NOT PUT YOUR FINGERS IN FRONT OF THE PISTON**. A little compressed air and POP, out if came. I used a block of wood and a rag to dampen the blow. I then removed the dust boot and looked inside. Yuk! a lot of nasty stuff in there.
Attached Images
     
__________________
My Chevy habit is paid for by Ford diesels...
Here is my SLOW LS install: http://67-72chevytrucks.com/vboard/s...55#post6456355
Caliper Rebuild: http://67-72chevytrucks.com/vboard/s...d.php?t=613748
Upper Control Arm Bushings: http://67-72chevytrucks.com/vboard/s...d.php?t=616974
IG mattcrp1
mattcrp1 is offline  
Old 01-25-2014, 05:02 PM   #2
mattcrp1
Registered User
 
mattcrp1's Avatar
 
Join Date: May 2010
Location: Mountain House, CA
Posts: 555
Re: 76 Caliper Rebuild

After I cleaned up the caliper and piston I started the assembly proccess. If there are any scores, lines or pits on the piston do not reuse it. I used some 1200 grit sandpaper to polish the piston. It looked pretty good. I cleaned the caliper body and had to scrape a deposit out. I used a scotch brite pad to clean the inside bore of the caliper, mainly to remove any stains. I then used some fresh brake fluid on the new square cut oring and installed it into the caliper. I lubed the piston with brake fluid as well and pressed it into the caliper, before the piston was all the way down into the bore I installed the dust seal. Now that it done I can paint it and install it. Feel free to add to ask questions or crticizes. I just thought I would post this simple process, I noticed when doing a search that some guys were a little hesitant to rebuild a caliper. Hope this helps.

Matt
Attached Images
     
__________________
My Chevy habit is paid for by Ford diesels...
Here is my SLOW LS install: http://67-72chevytrucks.com/vboard/s...55#post6456355
Caliper Rebuild: http://67-72chevytrucks.com/vboard/s...d.php?t=613748
Upper Control Arm Bushings: http://67-72chevytrucks.com/vboard/s...d.php?t=616974
IG mattcrp1
mattcrp1 is offline  
 

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 12:30 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com