The 1947 - Present Chevrolet & GMC Truck Message Board Network

The 1947 - Present Chevrolet & GMC Truck Message Board Network (https://67-72chevytrucks.com/vboard/index.php)
-   Racing and high performance (trucks haulin more than hay) (https://67-72chevytrucks.com/vboard/forumdisplay.php?f=60)
-   -   Ok Boys and Girls it's Storytime (https://67-72chevytrucks.com/vboard/showthread.php?t=384900)

regan wilson 01-07-2021 11:47 AM

Re: Ok Boys and Girls it's Storytime
 
My front brake rotors were pretty toasted after we ran it wide open at the end of 2019. The short downhill shutdown at that track was a little hard on them. So I figured it was time for new rotors and pads.

https://hosting.photobucket.com/imag...080&fit=bounds

regan wilson 01-07-2021 12:03 PM

Re: Ok Boys and Girls it's Storytime
 
Other than all that I pulled the carbs and cleaned them up. New floats and needle & seats
When I turned on the fuel pump it picked up 4lbs of fuel pressure. That tells me I had a problem. All I have left to do to the truck is mount my new front tires, check and or adjust the floats and clean it up. I've also been working on the race trailer. The brakes were a mess. We literally threw a bunch of used junk together so I could make the last two races. I got new backing plates and hubs. I've got the plates on and wired. I'm just putting off the messy job of packing bearings and putting the hubs on. I do have to get done in the next couple of weeks. The next project is head studs and gasket on my old Dodge. Appearently 40lbs of boost with stock head bolts will get you sooner or later. Right now everything is on jack stands .Lol

https://hosting.photobucket.com/imag...080&fit=bounds

regan wilson 01-07-2021 12:05 PM

Re: Ok Boys and Girls it's Storytime
 
Even though I had a terrible race season in 2020 I did get a little ink from the Fall Nationals.

https://hosting.photobucket.com/imag...080&fit=bounds

regan wilson 01-07-2021 12:08 PM

Re: Ok Boys and Girls it's Storytime
 
Quote:

Originally Posted by SCOTI (Post 8860285)
Those should help w/tuning the suspension. Going to have to get a fresh notebook for the comp/rebound/track/set-up data.

You're right Scoti. They have 20 something settings on compression and rebound both. You can play with them and really tell how much each adjustment does.

aggie91 01-08-2021 04:59 PM

Re: Ok Boys and Girls it's Storytime
 
Quote:

Originally Posted by regan wilson (Post 8860313)
Even though I had a terrible race season in 2020 I did get a little ink from the Fall Nationals.

https://hosting.photobucket.com/imag...080&fit=bounds

Dirty Feet...

regan wilson 01-08-2021 05:40 PM

Re: Ok Boys and Girls it's Storytime
 
Lol Karl.

mongocanfly 01-09-2021 06:02 PM

Re: Ok Boys and Girls it's Storytime
 
You've been busy..!!..glad you found the steering culprit...that was easy..

regan wilson 01-10-2021 12:22 AM

Re: Ok Boys and Girls it's Storytime
 
Thanks Greg.

regan wilson 01-28-2021 11:18 AM

Re: Ok Boys and Girls it's Storytime
 
https://hosting.photobucket.com/imag...080&fit=bounds

Well by this picture everything appears to be ready to go. I probably have an hours work finishing up the Blue Truck.

regan wilson 01-28-2021 11:20 AM

Re: Ok Boys and Girls it's Storytime
 
https://hosting.photobucket.com/imag...080&fit=bounds

But then there's this little issue to deal with.

regan wilson 01-28-2021 11:26 AM

Re: Ok Boys and Girls it's Storytime
 
https://hosting.photobucket.com/imag...080&fit=bounds

I took this hunk of iron to the machine shop Monday. They called me and said its good and solid but needs a few guides. I told them to just make it right. I have a Mahle head gasket and ARP studs here for it. When I busted the head bolts loose that I had to do by hand some didn't feel very tight. I think the last idiot that I let work on it reused the bolts. That's what I get for not studding it to begin with. Hopefully I will have it back by tomorrow. Maybe My chest will feel better by Saturday. I feel like I've been Donkey Kicked in the chest from planking on the core support,Lol

SCOTI 01-28-2021 12:48 PM

Re: Ok Boys and Girls it's Storytime
 
Quote:

Originally Posted by regan wilson (Post 8871168)
https://hosting.photobucket.com/imag...080&fit=bounds

I took this hunk of iron to the machine shop Monday. They called me and said its good and solid but needs a few guides. I told them to just make it right. I have a Mahle head gasket and ARP studs here for it. When I busted the head bolts loose that I had to do by hand some didn't feel very tight. I think the last idiot that I let work on it reused the bolts. That's what I get for not studding it to begin with. Hopefully I will have it back by tomorrow. Maybe My chest will feel better by Saturday. I feel like I've been Donkey Kicked in the chest from planking on the core support,Lol

Gotta get you one of those planking creepers. Nice padding. Steps to climb on to get you to the pad/platform. They're work the 250ish they go for.

regan wilson 02-01-2021 09:25 AM

Re: Ok Boys and Girls it's Storytime
 
The old Goat is up and running as of yesterday. Everything went back together pretty well. It is a little tiring getting 26 studs to 125lbs of torque with a short torque wrench. After a few Ken was reaching over and helping me pull.

regan wilson 02-27-2021 08:26 AM

Re: Ok Boys and Girls it's Storytime
 
Well guys I'm in South Louisiana in Belle Rose. I unloaded Thursday when I got here to get the golf cart out and put the truck back in. I thought something looked funny about the truck but didn't figure it out till yesterday morning.

https://hosting.photobucket.com/imag...w/IMG_3109.JPG


See the gap in the bed ? That s*** aint right.

regan wilson 02-27-2021 08:27 AM

Re: Ok Boys and Girls it's Storytime
 
Look at the C Notch! And look at the wheel tub and the kink in the bed floor.

https://hosting.photobucket.com/imag...w/IMG_3103.JPG

regan wilson 02-27-2021 08:29 AM

Re: Ok Boys and Girls it's Storytime
 
Yep the old truck is broke in half behind the axle.https://hosting.photobucket.com/imag...w/IMG_3108.JPG

regan wilson 02-27-2021 08:35 AM

Re: Ok Boys and Girls it's Storytime
 
I've got it strapped up jacked up and rigged up to try and get it home with no more damage if possible. I'll take it over to my friend Tony next week. We will get it straightened out and welded up. Then I'm going to add some more tubing off the strut bars to go further back behind the rearend. I spent yesterday helping some of my friend and borrowing different straps and such to get it road ready. I'll post a pic of that later. It's going to be a long ride home. I'll be stopping to check everything about every 50 miles.

SCOTI 02-28-2021 12:33 PM

Re: Ok Boys and Girls it's Storytime
 
I hate to say it but that notch depth (even boxed in) makes that area of frame weak for a stock truck. Scary weak for the power & stress you're putting to it.

regan wilson 03-01-2021 07:26 AM

Re: Ok Boys and Girls it's Storytime
 
You're right on that Scotti. I have wanted to add some bars for awhile now. I was too busy this winter to even think about it. I had a laundry list of things to work on from October till February. On top of that I had an abnormal business work load in January. I hope we can start on it by Thursday. When it's done it will be better than ever. I believe there was already some damage causing erratic 60ft times.

regan wilson 03-02-2021 06:45 AM

Re: Ok Boys and Girls it's Storytime
 
https://hosting.photobucket.com/imag...w/IMG_3121.JPG

https://hosting.photobucket.com/imag...w/IMG_3120.JPG

Well I took a couple of days to look at it and think about it. The damage was a little worse than I could see. I took the anti-roll out of it and gently jacked it up from the middle and the back so I could get in there with a sawzall. I cut out the two sections of what is left of the middle bed braces so Tony can weld the top. That will help relieve the bent bed floor in hopes of fixing the floor and the tubs. It ain't pretty.

aggie91 03-03-2021 10:00 AM

Re: Ok Boys and Girls it's Storytime
 
Damn, I am glad you saw this before making more passes, that could have ended badly.

Make sense now seeing this damage as to why you were having 60ft issues.

Is it Tony Smith that will help you out?

regan wilson 03-03-2021 10:49 AM

Re: Ok Boys and Girls it's Storytime
 
Yea Karl hopefully we can get started on it tomorrow. I told him I would bring it and stay with him to get the frame back in place. Once we get that done he can add the bars. We may tie the bars in with the shock mount and then tie into the frame afterwards. We'll just have to look it over and figure out the best solution. And you know I want it to look right.

mongocanfly 03-03-2021 09:10 PM

Re: Ok Boys and Girls it's Storytime
 
Dang Regan...that coulda been bad..good thing you caught it when you did..!!!..

regan wilson 03-04-2021 07:22 AM

Re: Ok Boys and Girls it's Storytime
 
Greg if I didn't notice it before I staged. I'm sure I would have when I let go of the transbrake. It wouldn't have been good at all.

regan wilson 03-05-2021 08:51 AM

Re: Ok Boys and Girls it's Storytime
 
https://hosting.photobucket.com/imag...080&fit=bounds

Well we got a good start on the truck yesterday. We got in the air which was a chore in itself. I pulled everything out of the frame rails. Fuel line and wires etc.


All times are GMT -4. The time now is 11:22 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com