Bucket seats
 

I wanted to see if anyone could identify these seats. What do they come out of? All help is appreciated.

http://i810.photobucket.com/albums/z...g?t=1298168473

http://i810.photobucket.com/albums/z...g?t=1298168496

http://i810.photobucket.com/albums/z...g?t=1298168473
http://i810.photobucket.com/albums/z...g?t=1298168496
http://i810.photobucket.com/albums/z...g?t=1298166822

Re: Bucket seats
 

They look like 71/72 truck buckets to me, with different covers.

Re: Bucket seats
 

Thanks a lot. I am wanting to recover them but trying to make sure what I have.
Posted via Mobile Device

Re: Bucket seats
 

Is there any way to tell the difference between the 71-72 and 73-75 once covered? I am not aware of any but wanting to verify if the frames may be different? Maybe where the bolt holes are?

Re: Bucket seats
 

The 73-75 seats are very close to the 71-72s. I've never encountered any appreciable difference that would not allow you to install 71-72 cover on these type. However, after 75 the low back seats change on the upper portion of the seat back.

Re: Bucket seats
 

I did not see the third pic initially. The floor mounting brackets are not 69-72 truck.

Re: Bucket seats
 

If those are original covers they sure survived amazingly. If they are original,I want to say the look could be Dodge. Just a guess,but I think that's the design I remember seeing.

Re: Bucket seats
 

1973-1974 bucket seats out of a truck, blazer, or burb. Trevor

Re: Bucket seats
 

The 73-74 bracket mounting holes are a little different. On the front floor mounting bracket, the blazer brackets will only line up with two of the three holes on the passenger side. They will work, but not exactly the same. You could mark and weld in a nut to the factory location of the 71-72.

Re: Bucket seats
 

That's what I was thinking...how did you identify them?

Re: Bucket seats
 

Thanks for the help..Would i have problems installing them on a 70 c10? which seat brackets should i get for them? Thanks Again Dave

Re: Bucket seats
 

The drivers side should line up fine. On the truck brackets for the passenger side, I would get a repro set and mount them up. You should be able to drill the mismatched hole in the bracket and bolt it to the seat core. No one will know the difference.

Re: Bucket seats
 

Thanks John H, and everyone else for the help... Dave
Posted via Mobile Device