The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Scrub · 12-03-2002, 11:50 PM

I am putting the big 1410 u-joints to the rear end, but I am wondering about the front drive line.

I think I need a CV joint on the front driveline and I don't even know if a 1410 is available. I am thinking 1350's

I have both 1350 and 1410 drivelines to cut down so the cost there is about the same if a CV is not manditory.

It's a 205 case and 4 inch lift with Dana 60 front.

Anyone have experience with this?

Thanks in advance

12-03-2002, 11:50 PM	#1
Scrub Collector of rusty Items Join Date: Dec 2001 Location: Sisters,Oregon USA Posts: 731	Front Driveline questions I am putting the big 1410 u-joints to the rear end, but I am wondering about the front drive line. I think I need a CV joint on the front driveline and I don't even know if a 1410 is available. I am thinking 1350's I have both 1350 and 1410 drivelines to cut down so the cost there is about the same if a CV is not manditory. It's a 205 case and 4 inch lift with Dana 60 front. Anyone have experience with this? Thanks in advance __________________ Scrub Sisters, Oregon - Home of the Sisters Rodeo. 70 GMC 1,000,000 + miles 72 K-20 project, 456 Dana60 front, Corp14 rear w/locker, 265R19.5 tires 20-ply. Warn 12k winches both ends, Cross-over steering with raised tie-rod, Powerbox steering, 4500 watt 120-AC power, Air, Hydraulic aux power, 4 inch lift, 5000 lb air-bags both ends.