The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Dropmember Rear 63-72 Spy Pic

PBFAB.COM · 08-12-2008, 09:20 PM

Ok guys... Here's the updated pics of the production Dropmember Rear.

- Bolt-in notch with integrated bridge (available to lay frame from 26" to 32" tire diameters; designed for a 5" ride height)

-Sleeved bags mounted over the axle for increased stability and ride quality.

- Bolt-on arallel four-link with panhard bar (axle plunges .625" from ride height to dump; axle shifts lateraly .375 inches from ride height to dump)

-Carrier bearing crossmember (allows the use of two-piece drive-shaft, eliminating cab tunneling)

08-12-2008, 09:20 PM	#105
PBFAB.COM Senior Member Join Date: Dec 2003 Location: Mesa,Az Posts: 3,981	Re: Dropmember Rear 63-72 Spy Pic Ok guys... Here's the updated pics of the production Dropmember Rear. - Bolt-in notch with integrated bridge (available to lay frame from 26" to 32" tire diameters; designed for a 5" ride height) -Sleeved bags mounted over the axle for increased stability and ride quality. - Bolt-on arallel four-link with panhard bar (axle plunges .625" from ride height to dump; axle shifts lateraly .375 inches from ride height to dump) -Carrier bearing crossmember (allows the use of two-piece drive-shaft, eliminating cab tunneling) Attached Images __________________ www.PorterbuiltFabrication.com Phone: 480-297-2621 E-mail: sales@pbfab.com Find us on FaceBook under Porterbuilt Fabrication Specializing in Chassis and Suspension Components for your Classic Chevrolet Truck. We offer components from the following manufacturers: Porterbuilt Accuair Ridetech (Air Ride Technologies) Air Lift Wilwood Intro Unisteer ECE Gotta Show Air Lift Borgeson CPP Supporting this forum since 2003!