Quote:
Originally Posted by Damien
It helps to have a wiring diagram for the donor vehicle. It will take about half a day to sort out and remove all the unneeded circuits. The harness on the newer style trucks comes through the fire wall on the passenger side near the heater box, so some of the wires may be too long or short for a factory appearing installation. Good luck. This should be helpful for a lot of people.
|
The harness I am using came from a 87 truck (thanks beater c-10), I also had a 90 suburban I bought for parts and I have that harness also to save for anouther project. Anyway I will show everybody tomarow where the stock suburban harness came out of the truck. It is in the same location on this 86 truck because it had the esc distribitor from the factory. I am going to use this hole.( It's on the pass side also)
I looked at a 92 today and they would probably have a little extra wire if you use that harness but not so much that you could not make it look factory if you wanted to.