Got the last bolt (driver floor) out on Sunday morning - PITA!
Had to cut the floor around it to get it out since it was rusted/welded all the way around and it would not release - that shouldn't really matter since I will likely be replacing the floors anyway.
After that fiasco I checked the doors - had to add a few shims here and there, but the doors open/close as they should.
After I went to put the driver floor pan bolt back in - it wouldn't go in - it was like the body had shifted and wouldn't allow the bolt to drop through the mount/frame...WTF!
All the other bolts lining up with the mounts were OK for the most part - one of the rears was tricky - but it eventually went back in.
Now I know I will have to remove that bolt again to get the new floors back in -
How can I get this shifted back over to drop the bolt through the floor mount when I replace the driver side floor metal - any advice?
So - now the first step of the process is out of the way for rust repairs...
1. Replace Body Mounts if crappy - done
2. Have Top Bolted to the Body & Windshield Frame - my w/s frame is rusted out so the top isn't bolted to it - any advice here on how to proceed?